Edible cocktails with gelatin
Tuesday, October 16th, 2007
Recipes for Bluberry martini jelly shots (top right), B-52 jelly shots (bottom right), Prosecco gelée (middle left) and Gin and Tonic gelée (middle) are given below.
Just wanted to point you to a beautiful picture gallery of edible cocktails accompanying an article by Betty Hallock at LA Times, “Cocktails you can eat”.
The recipes (shortened and converted to metric units by me) are as follows:
Blueberry martini jelly shots
300 mL vodka (blueberry flavored)
60 mL simple syrup
25 g gelatin (6.9%)
35 fresh blueberriesMix vodka and syrup in small saucepan. Add gelatin and leave for 5-10 min until soft. Gently heat saucepan and stir until gelatin dissolves (approx. 10 min). Strain to remove any undissolved gelatin. Place bluberry in cocktail mold and pour vodka mixture into each mold. Cool until set. Makes about 35 cocktails of 15 mL each. (Adapted from Bar Nineteen 12)
Prosecco gelée
1 length of a vanilla bean
140 g sugar
15 g gelatin sheets, bloomed (3.1%)
340 mL Prosecco (or other white wine)Scrape seeds from vanilla bean and mix thoroughly with sugar. Mix water and sugar in saucepan and heat over high heat until syrup almost comes to a boil. Remove from heat and bloomed gelatin and stir until it dissolves. Add wine and stir gently. Pour into 20 x 20 cm pan lined with plastic wrap and cool until set. Cut into squares, turn upside down to display settled vanilla beans and serve. (Adapted from Craft pastry chef Catherine Schimenti)
B-52 jelly shots
170 mL Kahlúa
170 mL Baileys
170 mL Grand Marnier
24 g gelatin sheets (4.7%)Place each liqueur in separate bowls and add 8 g gelatin to each. Cover and leave until gelatin has softened. Pour Kahlúa/gelatin into a saucepan and heat over low heat until gelatin dissolves. Strain to remove any remaining solids. Pour liquid into a 10 x 20 cm pan lined with plastic wrap. Cool for about one hour. Repeat with Baileys, and then with Grand Marnier, pouring the newly prepared liqueur on top of the set liqueur in the mold. Cut into pieces and serve. (Adapted from Bar Nineteen 12)
Gin and tonic gelée
170 mL gin
10 g gelatin (2.2%)
280 mL tonic water
finely grated zest of 4 to 5 limes
1 T citric acid
1 1/2 t baking soda
1 T powdered sugarLet the gelatin soften in gin for 5-10 min. Heat over low heat and stir until gelatin has dissolved. Pour in tonic water carefully (to avoid it from bubbling over), swirl the contents to obtain a homogeneous mixture and immediatly pour contents into 40 mL molds. Cool. To serve, unmold the gelée and sprinkle each cocktail with lime zest and a little of the premixed citric acid, baking soda and powdered sugar. Serve immediately. (Adapted from Providence pastry chef Adrian Vasquez) For reference, you might want to compare this recipe with Eben Freeman’s Jellied G&T.
You might notice that the amount of gelatin varies over a pretty large range from 2.2-6.9%. This is also well above the typical concentration found in jellies (0.6-1%). A possible reason for the large range would be that alcohol interferes with the setting of gelatin, and a quick plot of gelatin vs. alcohol content suggests that this might be the case.
But as you can see from the B-52 jelly shots, the same concentration of gelatin is used for Baileys (17% alcohol), Kahlúa (26.5% alcohol) and Grand Marnier (40% alcohol), so there should be some room for variation here (I doubt that the resulting variation in texture was actually intended in this recipe). So if we round off, the linear regression yields the following correlation between gelatin and alcohol:
% gelatin to add = (% alcohol in final mix x 0.1) + 2
One thing that surprises me is that none of the recipes call for gellan? This hydrocolloid is said to have superior flavor release properties as it is more prone to break once you chew it. From what I know, it should work fine with alcoholic beverages. Has anyone tried this yet?
